CPU-76-118D (70-80 Shore D)

Key feature

● Hardness: 70-85D

● Mixing ratio: 1:1

● Pot life: 15-30min

● High transparency

● Excellent durability

● Outstanding adhesion


CPU-76-118D can be applied to various substrates. Its applications include molding models, doming decals, nameplates and ornaments, and encapsulating electronic parts.

Technical Product Data


Physical Properties

Testing Methods


Hardness (at 25)

ASTM D 2240 D

(Teclock GS-702N)

Shore D 70-85


RoHS requested methods

Pb below the limit, others not detected

Heavy metal

European standard EN 71


 * These items are provided as general information only. They are approximate values and are not considered part of the product specification.


CPU-76-118D is an excellent two-component polyurethane resin. It has high transparency and great adhesion to various substrates. Its durability is pretty impressive. It can withstand vicious surroundings, including cold, hot, dry or wet environments.

Guidelines for Manual Processing (It can also be dispensed with auto-dispensers.)

1. Keep the operation place as dustless as possible to gain products with better appearance. The ambient temperature is recommended at between 15°C and 25°C.


2. Calculate the needed amount in weight. Sequentially pour Part A and Part B into a clean and dry container. Unused components must be tightly closed to prevent contamination of dust and moisture from the air. The weight ratio of Part A to Part B is 1:1.


3. Immediately agitate the mixture with an electric stirrer or manually with a stirring blade for 30 seconds to 1 minute till it is well mixed.


4. Place the well blended mixture in a degassing equipment for 1 to 4 minutes.


5. Immediately start dispensing the mixture onto substrates. The operating time is about 15 to 30 minutes. Higher the ambient temperature and more the blended amount, the operating time would be shorter.


6. Put the coated substrates in an oven. Higher the oven temperature, they can be cured faster. Normally they can be cured in two hours at 80°C. For other curing temperatures and periods, please refer to the following table. As there’re always some tiny bubbles remaining in the mixture, a blast of hot air by a flame gun is helpful to eliminate residual bubbles near the surface. To reach full hardness, it’s recommended to cure it with 80°C or higher temperature.


T °C


T °C


50 °C

10 hours

90 °C

1 hour & 30 minutes

60 °C

6 hours

100 °C

1 hour

70 °C

3 hours

120 °C

40 minutes

80 °C

2 hours

150 °C

20 minutes

Notice: These values are based on the test of our present laboratory test specimens.


5kg/PE drum and 200 kg/metal drum.

Handling & Safety

1. Please wear a mask of charcoal filter, gloves and goggles while operating. And maintain good ventilation.

2. In case contacting the resin, no matter which part of the body, please wash it with plenty of soap and water at once. Seek medical attention, if you feel unwell.